Differences

This shows you the differences between two versions of the page.

--- digital_output_group [ 08.10.2025 14:20] – lars
+++ digital_output_group [ 10.10.2025 01:44] (current) – lars
@@ Line 8: / Line 8: @@
     "digital_output": {
         "green_led": {
-            "type": "push pull"
+            "type": "push pull",
-            "pad": "PA3"
+            "pad": "PA3",
+            "on_boot": "enabled"
         }
     }
@@ Line 34: / Line 35: @@
 ==== invert ====
-If this setting is set to "on" then turning this output "on" will generate a Low (Gnd) signal. Turning it "off" will generate a High (Vcc) level.
+If this setting is set to "enabled" then turning this output "on" will generate a Low (Gnd) signal. Turning it "off" will generate a High (Vcc) level.
-If this setting is set to "off" (=default) then turning this output "on" will generate a High (Vcc) signal. Turning it "off" will generate a Low (Gnd) level.
+If this setting is set to "disabed" (=default) then turning this output "on" will generate a High (Vcc) signal. Turning it "off" will generate a Low (Gnd) level.
-**type**: string
+**type**: bool
-**default**: "off"
+**default**: "disabled"
 ==== pull_up ====
@@ Line 57: / Line 58: @@
 **default**: disabled
+==== on_boot ====
+defines the logic level to be set on initialization. Setting this to "enabled" will set the pin High (Vcc) if inverted is disabled.
+**type**: bool
+**default**: disabled
+==== drive_strength ====
+defines the amount of current that can be driven from the pin. Possible values are:
+  * 2mA
+  * 4mA
+  * 8mA
+  * 12mA
+**type**: enum
+**default**: 2mA
+==== slew_rate ====
+defines the rise and fall times. Possible values are:
+  * slow
+  * fast
+**type**: enum
+**default**: "slow"
 ===== API =====