MBSP

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
===== general settings =====

these are settings on the top layer that effect the whole project.
   
==== vendor_name ====

Name of the company that sells the micro controller. As listed on https://chipselect.org

**type**: string

==== chip_name ====

Model number of the micro controller. As listed on https://chipselect.org

**type**: string

Model number is truncated so that it only contains relevant differences for code generation: flash and ram sizes are relevant, temperature range or package are not.


==== project_type ====

what type of project to generate.

**type**: enum

**default**: "make"

Possible values are:
  * "hal only" : only creates the hardware driver files (in the hal/ folder) and hardware definitions (in the hal/hw/ folder)
  * "embeetle" : create an Embeetle IDE project
  * "make" :  creates a makefile based "blinky" project.


==== file_comment ====

defines the comment at the top of each generated file.

**type**: enum

**default**: "created"

Possible values are:
  * "created" : file comment list date and time of file creation as well as configuration file name.
  * "minimal" : short comment only stating the file name and that it was automatically created.

==== run_from ====

defines the location of the firmware code when run.

**type**: enum

**default**: "flash"

Possible values are:
  * "flash" : firmware is located and run from the flash memory.
  * "ram" : firmware is located and run from the RAM.
  * "flash2ram" : firmware is located in flash, copied to RAM on boot and then executed from RAM.

==== path_prefix ====

if you use a "hal only" MBSP project located in a sub folder of your project then the name of the sub folder goes here.

**type**: string

**default**: ""

==== error_handling ====

if something unexpected (like a hard fault) happens this defines what should happen:

**type**: enum

**default**: "halt"

Possible values are:
  * "halt" : firmware stops executing.
  * "reset" : firmware resets.